

- MAX307CWI+T - 集成电路(IC) > 接口 > 模拟开关,多路复用器,解复用器
- MAX5487ETE+TC9E - 集成电路(IC) > 数据采集 > 数字电位计
- MAX4603CPE - 集成电路(IC) > 接口 > 模拟开关,多路复用器,解复用器
- 71M6203-ILR/F - 集成电路(IC) > 电源管理(PMIC) > 电能计量
- MAX86176ENX+T - 传感器,变送器 > 专用传感器
- MAX6717UKTZD6+T - 集成电路(IC) > 电源管理(PMIC) > 监控器
- MAX30207ACLB+T - 传感器,变送器 > 温度传感器 > 模拟和数字输出
- MAX20086ATPA/VY+ - 集成电路(IC) > 电源管理(PMIC) > 电流调节/管理
- MAX5132AEEE - 集成电路(IC) > 数据采集 > 数模转换器(DAC)
- MAX5991BETP+ - 集成电路(IC) > 电源管理(PMIC) > 以太网供电(PoE)控制器
- MAX3676EHJ-T - 集成电路(IC) > 时钟/定时 > 应用特定时钟/定时
- MAX3222EUP+ - 集成电路(IC) > 接口 > 驱动器,接收器,收发器
- MAX1577YETA+T - 集成电路(IC) > 电源管理(PMIC) > LED 驱动器
- MAX17501GTEVKIT# - 开发板,套件,编程器 > 评估板 > DC/DC 和 AC/DC(离线)SMPS 评估板
- MAX9789CETJ+ - 集成电路(IC) > 线性 > 放大器 > 音频放大器
- MAX4885EETG+T - 集成电路(IC) > 接口 > 模拟开关 - 特殊用途
- MAX5056BASA+T - 集成电路(IC) > 电源管理(PMIC) > 栅极驱动器
- MAX16826BATJ/V+T - 集成电路(IC) > 电源管理(PMIC) > LED 驱动器
- MAX995ESD+T - 集成电路(IC) > 线性 > 比较器
- MAX739EWE+ - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - DC-DC 开关稳压器



MAX5911 - -48V、Simple Swapper热插拔开关
MAX5911是Maxim美信半导体公司的一款热插拔和电源开关产品,MAX5911是-48V、Simple Swapper热插拔开关,本站介绍了MAX5911的封装应用图解、特点和优点、功能等,并给出了与MAX5911相关的Maxim元器件型号供参考。
MAX5911 - -48V、Simple Swapper热插拔开关 - 热插拔和电源开关 - -48V热插拔开关,适用于IP电话和通过同一电缆传输数据、电源的数据终端设备 - 美信半导体
The MAX5911/MAX5912 are fully integrated hot-swap switches for negative supply rails. These devices allow the safe insertion and removal of circuit cards into live backplanes or ports without causing problematic glitches on the negative power-supply rail. They also monitor various circuit parameters and disconnect the load if a fault condition occurs, alerting the host with a logic-level FAULT-bar output. The MAX5911/MAX5912 operate over a voltage range of -16V to -65V and are designed to permit hot plugging of an IP phone into a hub, but are not limited to that operation.
During startup, an internal power FET regulates the current between the backplane power source and the load to 280mA for MAX5911 and 415mA for MAX5912. After startup, the FET is fully enhanced to reduce its on-resistance. To ensure robust operation, the MAX5911/MAX5912 contain built-in safety features that prevent damage to the internal FET. They include an enable input, which responds to positive logic signals (+3.3V or +5V), allowing the host system to disconnect the load. ENABLE is also used to reset the device after a latching fault condition occurs.
The MAX5911/MAX5912 Simple Swapper™ hot-swap ICs monitor four parameters for these fault conditions: undervoltage lockout (UVLO), power-not-good, zero-current detection, and thermal shutdown. These devices are available in the extended temperature range, -40°C to +85°C. The MAX5911 and MAX5912 come in 8-pin and 16-pin SOIC packages, respectively.
- MAX6655 - 双路远端/本地温度传感器及四路电压监测器
- MAX11626 - 12位、300ksps ADC,带有FIFO和内部电压基准
- MAX6730 - 单/双/三电压微处理器监控电路,带有独立的看门狗输出
- MAX1106 - 单电源、低功耗、串行8位ADC
- MAX3023 - +1.2V至+3.6V、0.1µA、100Mbps、单/双/四路电平转换器
- MAX887EVKIT - MAX887评估板
- DS1307 - 64 x 8、串行、I²C实时时钟
- MAX3491 - 3.3V供电、10Mbps、限摆率、真RS-485/RS-422收发器
- MAX892L - 限流型、高边P沟道开关,带有热关断
- MAX3232 - 3.0V至5.5V、低功耗、1Mbps、真RS-232收发器,使用四只0.1µF外部电容



