The MAX807 microprocessor (µP) supervisory circuit reduces the complexity and number of components needed to monitor power-supply and battery-control functions in µP systems. A 70µA supply current makes the MAX807 ideal for use in portable equipment, while a 2ns chip-enable propagation delay and 250mA output current capability (20mA in battery-backup mode) make it suitable for larger, higher-performance equipment.

The MAX807 comes in 16-pin DIP, SO, and TSSOP packages, and provides the following functions:

µP reset. The active-low RESET output is asserted during power-up, power-down, and brownout conditions, and is guaranteed to be in the correct state for VCC down to 1V.

Active-high RESET output.

Manual-reset input.

Two-stage power-fail warning. A separate low-line comparator compares VCC to a threshold 52mV above the reset threshold. This low-line comparator is more accurate than those in previous µP supervisors.

Backup-battery switchover for CMOS RAM, real-time clocks, µPs, or other low-power logic.

Write protection of CMOS RAM or EEPROM.

2.275V threshold detector provides for power-fail warning and low-battery detection, or monitors a power supply other than +5V.

BATT OK status flag indicates that the backup-battery voltage is above +2.275V.

Watchdog-fault output—asserted if the watchdog input has not been toggled within a preset timeout period.

• MAX9388 - 差分5:1或4:1 ECL/PECL多路复用器，带有单/双输出缓冲器
• MAX5816 - 内置基准和I²C接口的超小尺寸、4通道、12位缓冲输出DAC
• MAX3088E - ±15kV ESD保护、失效保护、高速(10Mbps)、限摆率RS-485/RS-422收发器
• MAX3646 - 155Mbps至622Mbps SFF/SFP激光驱动器，带有消光比控制
• MAX5461 - 32抽头FleaPoT、2线数字电位器
• DS1233A - 3.3V、经济型复位芯片
• MAX385 - 高精度、低电压、SPST、CMOS模拟开关
• MAX8600A - 单输入、1节Li+电池充电器，提供OVP保护和可编程充电定时器
• MAX7422 - 五阶、低通、开关电容滤波器
• MAX2205 - RF功率检测器，UCSP封装